MOTO LED Resistor Wire

SPECIFICATIONS:

When standard bulb flasher is replaced by LED flasher, electric consumption becomes low and stock flasher relay does not work correctly. This Resistor wire help stabilize electric power for LED flasher from stock flasher relay.
・Electric consumption level is the same as with stock flasher.
・Easy installation.
・One resistor for one flasher.
※Some models(XR230, DR250R, DRZ400S/SM etc.)need 2 resistors.
・This harness will produce heat when used. Please install in area where heat is not a problem.

Part #

D45-90-710

♦Important note for using LED flasher

LED flashers have very low consumption and the stock flasher relay may not work properly.
The most frequent problem, is that the LED may be flash at a quick rate using stock flasher relays.
Please refer right side of chart to choose our IC relay or Resistor wire for your installation.

	Consumption	Difficulty of installation	Parts cost	AC or DC
IC Relay	Ο	Δ	Ο	DC
Resistor wire kit	Χ	Ο	Δ	DC/AC

*DRC IC Relay can not be used with motorcycles (XR50/100M, XLR250, WR250F/WR450F, XR650 etc)due to the AC power design. Please use Resister wire kit for AC power motorcycle.